2- Cut 2 -1/8" Thick Wood Strips

Our New Five Steps video is about building a Jig. I felt that the clip I put up a few weeks ago touched on this but not in enough depth. The 2nd step in Jig building is to cut 2 -1/8" thick wood strips to be used as guides for setting glass in the jig.

About  1/2" wide will be good. Clip the corners off the strips so the head of the strip cutter can get closer to the edge of the glass.

Join Our Email List

Success! Thanks For Joining Us! Check your email to confirm your subscription. And get our Thanks For Joining PDF with video link. Look for a zip file attached to the confirmation. Usually a little box in the lower left hand corner of the screen.

There was an error submitting your subscription. Please try again.

Email Address

Click Here To Go To the Video