Wednesday, October 19, 2016

3-Use Strip Cutter to Determine Where Strips Go

Our New Five Steps video is about building a Jig. I felt that the clip I put up a few weeks ago touched on this but not in enough depth. 

The 3rd step in Jig building is to use the strip cutter to figure where the strips should go. Then mark them, cut them to length and place them on the jig. 

This is important, make sure they are placed so that the bevel sits exactly where you want it cut. If it gets turned around, you want it to fall in the same place.

Join Our Email List


No comments: